700R4 Crossmember Chevelle 1964-1967 Convertible or Boxed Frame

 INCLUDES:

• FINISHED IN A BLACK POWDER COAT
• NEW MOUNTING HARDWARE (PURCHASE TRANSMISSION MOUNT SEPARATELY)

1964-1967 CONVERTIBLE OR BOXED FRAME (2 OPTIONS) (NOTE: DISTANCE BETWEEN CROSSMEMBER FRAME HOLES IS APPROXIMATELY 43-1/4 MEASURE YOUR FRAME OR CROSSMEMBER TO INSURE PROPER SELECTION)

INSTALLATION NOTES:

THE CROSSMEMBER IS INSTALLED WITH THE TRANSMISSION MOUNTING TAB POSITIONED TOWARDS THE FRONT OF THE CAR 

(NOTE:  DISTANCE BETWEEN CROSSMEMBER FRAME HOLES IS APPROXIMATELY 43-1/4  MEASURE YOUR 

FRAME OR CROSSMEMBER TO INSURE PROPER SELECTION

THE CROSSMEMBER IS INSTALLED SO THAT THE EXHAUST CLEARANCE HUMPS ARE CLOSED ON THE TOP AND OPEN ON THE BOTTOM

THE SUPPLIED ALUMINUM SPACERS ARE UTILIZED TO PROVIDE CUSTOM POSITIONING OF THE TRANSMISSION MOUNT THEY ARE TO BE POSITIONED BETWEEN THE CROSSMEMBER MOUNTING TAB AND THE TRANSMISSION MOUNT SELECT THE DESIRED AMOUNT OF SPACERS AND MATCH A BOLT OF PROPER LENGTH TO INSURE FULL ENGAGEMENT INTO THE TRANSMISSION MOUNT SOME APPLICATIONS WILL NOT REQUIRE ANY SPACERS

SOME VEHICLES OF THIS GENERATION ARE EQUIPPED WITH A CROSSMEMBER THAT BOLTS DIRECTLY TO THE VEHICLES FRAME RAIL, WHILE OTHERS ARE EQUIPPED WITH A CROSSMEMBER THAT UTILIZES A TAB THAT SETS ON THE FRAME RAIL AND IS THEN CLAMPED BY A STEEL CAP THAT IS EMBEDDED WITH A RUBBER LINER THE RCAEC1-350 CROSSMEMBER BOLTS DIRECTLY TO THE FRAME RAIL AND UTILIZES THE FACTORY FRAME HOLES TO UTILIZE THE PROVIDED 7/16 HARDWARE IT IS NECESSARY TO ENLARGE THE HOLES IN THE FRAME RAILS WITH A 1/2" DRILL IF THE INSTALLER CHOOSES TO UTILIZE THE STOCK SIZE 3/8 HARDWARE IT IS STRONGLY RECOMMENDED THAT THE INSTALLER OBTAIN GRADE 8 FASTENERS AND WASHERS TO COMPENSATE